The distribution kit of Prolog consists of two 1.44 MB HD diskettes. For the Windows 3.x versions only, three additional diskettes contain the Win32S runtime system.

Attention:

If you install IF/Prolog under Windows 3.x, then you have to install Win32S first. For that read paragraph Installing Win32S for Windows 3.x first.

Installing the IF/Prolog system

To install the IF/Prolog system, please proceed as follows:

• Put Disk 1 of the distribution kit into your diskette drive.

• Activate the installation program setup.exe on Disk 1. This may be done by activating the diskette drive in your file manager or explorer and then double clicking on setup.exe.

• You will be asked, in which directory your IF/Prolog shall be installed.

  This directory will be your PROROOT directory.

• Then you will be asked for the name of a program group. You can either select an existing program group from the list shown, or choose your own group name, or select the default.

• When the installation is complete you should open your PROROOT directory and check if the following subdirectories exist:

                 ..\bin
  	       ..\c
                 ..\demo
                 ..\prolib
  

  Additionally, a file named key should exist in the PROROOT directory. It holds your personal license information. The proroot information will be set automatically into your autoexec.bat resp. config.sys file.

scroll to top