The distribution kit of Prolog consists of two 1.44 MB HD diskettes. For the Windows 3.x versions only, three additional diskettes contain the Win32S runtime system.

Attention:

If you install IF/Prolog under Windows 3.x, then you have to install Win32S first. For that read paragraph Installing Win32S for Windows 3.x first.

Installing the IF/Prolog system

To install the IF/Prolog system, please proceed as follows:

• Put Disk 1 of the distribution kit into your diskette drive.

• Activate the installation program setup.exe on Disk 1. This may be done by activating the diskette drive in your file manager or explorer and then double clicking on setup.exe.

• You will be asked, in which directory your IF/Prolog shall be installed.

  This directory will be your PROROOT directory.

• Then you will be asked for the name of a program group. You can either select an existing program group from the list shown, or choose your own group name, or select the default.

• When the installation is complete you should open your PROROOT directory and check if the following subdirectories exist:

                 ..\bin
  	       ..\c
                 ..\demo
                 ..\prolib
  

  Additionally, a file named key should exist in the PROROOT directory. It holds your personal license information. The proroot information will be set automatically into your autoexec.bat resp. config.sys file.